Added a new non-linear element [Angular contact ball bearing] (two-point contact, 5 degrees of freedom).
A module for taking into account the temperature state of rolling bearings has been added.
Added a module for accounting for changes in gaps due to mounting interference.
Added an algorithm for analyzing the condition of ball bearings [Rolling bearings].
Added a new non-linear element – [Dry Friction Bearing].
Added output of tangential stiffnesses and damping to nonlinear elements (Ball Bearing, Roller Bearing, Damper, Sliding Bearing).
Information on the current point in the [Nonlinear Analysis] algorithm is now also displayed for sorting modes by speed and relative time. The output speed for large models has been increased.
Added the ability to export graphs to the clipboard.
Added saving of graph settings when switching between sections in the [Imbalance Behavior] and [Nonlinear Analysis] algorithms.
Added functionality to save current chart settings between program launches. SP and GP (Set Print View and Get Print View) buttons.
Added buttons for copying graphs and 3D models to the clipboard.
Added buttons for copying graphs to an open Microsoft Word document (Active Python 2.7 must be installed).
Added Matrix Algebra calculator to the Tools menu.
Added buttons for managing legends on graphs (disable legends, display to the right of the graph).
Added a button to go to the matrix calculator from the compliance/stiffness/damping matrix dialog.
The addition of data post-processing algorithms to nonlinear analysis has been corrected (it was not considered, it was necessary to completely remove the nonlinear analysis algorithm).
Fixed restoration of selection in the protocol tree when opening the dialog again.
Information about the direction of the output data (X, Y, Z) has been added to the headings of the Imbalance Behavior, Nonlinear Analysis and data post-processing algorithms graphs.
Models were not loaded if there was a trunnion and load elements in the subsystem. Corrected.
Fixed the output of toolbars with buttons when the system resolution was set to 120dpi (they ran into the controls).
A bug leading to the lack of automatic calculation of model parameters when outputting a protocol has been fixed.